Brocade Communications Systems 6510 Installation Guide download pdf (Page 32)

Port side LED patterns during normal operation (Continued)TABLE 3

LED name LED color Status of hardware Recommended action

Blinking amber Attention is required. A number

of variables can cause this

status including a single power

supply failure, a fan failure, or

one or more environmental

ranges has been exceeded.

Check the management interface

and the error log for details on the

cause of status.

Contact your switch service

provider.

Ethernet Speed (green) No light Port speed is 10 Mbps. No action required.

Steady green Port speed is 100 Mbps. No action required.

Ethernet Activity/Link

(green)

No light There is no link. Verify that the Ethernet cable is

connected correctly.

Steady green There is a link. No action required.

Blinking green There is link activity (traffic). No action required.

Optical media port

status(one bi-color LED

for each FC port)

Off No light or signal carrier on

media interface.

Verify that the transceiver is

installed correctly and that the

cable is connected correctly.

Steady amber Receiving light or carrier, but

not online.

No action required.

Slow blinking

amber (2 sec)

Disabled (by diagnostics or by

portDisable command).

Verify that the diagnostic tests are

not being run. Reenable the port

using the portEnable command.

Fast blinking

amber (1/2 sec)

Port failure. Check the management interface

and the error log for details on the

cause of the failure. Contact

Technical Support if necessary.

Steady green Online. No action required.

Slow blinking

green (2 sec)

Online but segmented

(loopback cable or

incompatible switch).

No action required.

Fast blinking

green (1/2 sec)

Internal loop-back (diagnostic). No action required.

Flickering green Online, frames flowing through

port.

No action required.

Nonport side LED patterns during normal operation TABLE 4

LED name LED color Status of hardware Recommended action

Power supply/fan

assembly status

No light PS/fan is not receiving power or

is off.

Verify the PS/fan is on and seated and

the power cord is connected to a

functioning power source.

Brocade 6510 Operation

32 Brocade 6510 Hardware Installation Guide

53-1002174-10

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 65 66

Comments to this Manuals

No comments

Brocade Communications Systems 6510 Installation Guide Page 32

Comments to this Manuals

Related products and manuals for Network switches Brocade Communications Systems 6510