Brocade Communications Systems 6510 Installation Guide download pdf (Page 44)

FIGURE 12 DC power connector and cable receptacle with cable retainer screws

1. Cables

2. Fastening screws

Switch power supply and fan assemblies on the non-port side

• Disassembling any part of the power supply voids the part warranty and regulatory certifications.

There are no user-serviceable parts inside the power supply and fan assembly.

CAUTION

Changes or modifications made to this device that are not expressly approved by the party

responsible for compliance could void the user's authority to operate the equipment.

• The cooling system relies on pressurized air, do not leave either of the power supply and fan

assembly slots empty longer than two minutes when the Brocade 6510 is operating.

CAUTION

If you do not install a module or a power supply in a slot, you must keep the slot filler panel

in place. If you run the chassis with an uncovered slot, the system will overheat.

NOTE

If a power supply and fan assembly fails, leave the power supply and fan assembly in the Brocade

6510 until it can be replaced. Maintain both power supply and fan assembly in operational condition to

provide redundancy.

The following table describes the power supply and fan assembly status LED colors, behaviors, and

actions required, if any.

Power supply and fan assembly status LED behavior, description, and required actionsTABLE 6

LED Color Description Action Required

No light Power supply and fan assembly is not receiving

power, or is off.

Verify that the power supply and fan

assembly is on and seated and the

power cord is connected to a

functioning power source.

Removal and replacement of power supplies and fans

44 Brocade 6510 Hardware Installation Guide

53-1002174-10

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 65 66

No comments

Brocade Communications Systems 6510 Installation Guide Page 44