Brocade Communications Systems Mobility 7131 Series Installation Guide download pdf (Page 20)

Mounting the access point

12 Brocade Mobility 7131N-FGR Access Point Installation Guide

53-1001948-01

CAUTION

Ensure you are placing the antennas on the correct connectors to

ensure the successful operation of the Brocade Mobility 7131N-FGR

Access Point.

NOTE

It is recommended the access point be mounted with the RJ45 cable connector

oriented upwards or downwards to ensure proper operation.

11. Cable the access point using an approved line cord and power supply.

For standard power adapter and line cord installations:

a. Connect a RJ-45 CAT5e (or CAT6) Ethernet cable between the network data

supply (host) and the access point’s GE1/POE or GE2 port.

b. Verify the power adapter is correctly rated according the country of

operation.

c. Connect the power supply line cord to the power adapter.

d. Attach the power adapter cable into the power connector on the access

point.

e. Attach the power supply line cord to a power supply.

CAUTION

Do not actually connect to the power source until the cabling portion of

the installation is complete.

12. Verify the behavior of the access point LEDs. For more information, see “LED

indicators” on page 18.

13. The access point is ready to configure. For information on basic access point

device configuration, see “Configuring basic device settings” on page 27.

Suspended ceiling T-bar installations

A suspended ceiling mount requires holding the access point up against the T-bar

of a suspended ceiling grid and twisting the access point chassis onto the T-bar.

AP7131N_InstallationGuide.book Page 12 Tuesday, August 24, 2010 5:09 AM

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 64 65

No comments

Brocade Communications Systems Mobility 7131 Series Installation Guide Page 20