Brocade Communications Systems Mobility 7131 Series Installation Guide download pdf (Page 21)

Mounting the access point

Brocade Mobility 7131N-FGR Access Point Installation Guide 13

53-1001948-01

The mounting tools (customer provided) and hardware required to install the access

point on a ceiling T-bar consists of:

• Safety wire (recommended and customer supplied)

• Security cable (optional and customer supplied)

To install the access point on a ceiling T-bar:

1. Brocade recommends you loop a safety wire — with a diameter of at least 1.01

mm (.04 in.), but no more than 0.158 mm (.0625 in.) — through the tie post

(above the access point’s console connector) and secure the loop.

2. If desired, install and attach a security cable to the access point lock port.

3. Attach the antennas to their correct connectors.

For information on the antennas available to the access point, see “Antenna

options” on page 7.

CAUTION

Ensure you are placing the antennas on the correct connectors to

ensure the successful operation of the Brocade Mobility 7131N-FGR

Access Point.

4. Cable the access point using an approved line cord and power supply.

For standard power adapter and line cord installations:

a. Connect a RJ-45 Ethernet cable between the network data supply (host)

and the access point’s GE1/POE or GE2 port.

b. Verify the power adapter is correctly rated according the country of

operation.

c. Connect the power supply line cord to the power adapter.

d. Attach the power adapter cable into the power connector on the access

point.

e. Attach the power supply line cord to a power supply.

AP7131N_InstallationGuide.book Page 13 Tuesday, August 24, 2010 5:09 AM

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 64 65

No comments

Brocade Communications Systems Mobility 7131 Series Installation Guide Page 21