Brocade Communications Systems Mobility 7131 Series Installation Guide download pdf (Page 24)

Mounting the access point

16 Brocade Mobility 7131N-FGR Access Point Installation Guide

53-1001948-01

• Safety wire (strongly recommended)

• Security cable (optional)

To install the access point above a ceiling:

NOTE

Remove the access point’s facade and antennas before installing in an above the

ceiling orientation. The access point is not certified for an above the ceiling

installation with its accessories installed.

1. If possible, remove the adjacent ceiling tile from its frame and place it aside.

2. If required, install a safety wire, between 1.5mm (.06in.) and 2.5mm (.10in.) in

diameter, in the ceiling space.

3. If required, install and attach a security cable to the access point’s lock port.

4. Mark a point on the finished side of the tile where the light pipe is to be

located.

5. Create a light pipe path hole in the target position on the ceiling tile.

6. Use a drill to make a hole in the tile the approximate size of the access point

LED light pipe.

CAUTION

Brocade recommends care be taken not to damage the finished

surface of the ceiling tile when creating the light pipe hole and

installing the light pipe.

7. Remove the light pipe’s rubber stopper (from the access point) before installing

the light pipe.

AP7131N_InstallationGuide.book Page 16 Tuesday, August 24, 2010 5:09 AM

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 64 65

No comments

Brocade Communications Systems Mobility 7131 Series Installation Guide Page 24