Brocade Communications Systems Mobility 7131 Series Installation Guide download pdf (Page 26)

LED indicators

18 Brocade Mobility 7131N-FGR Access Point Installation Guide

53-1001948-01

a. Connect a RJ-45 Ethernet cable between the network data supply (host)

and the access point’s GE1/POE or GE2 port.

b. Verify the power adapter is correctly rated according the country of

operation.

c. Connect the power supply line cord to the power adapter.

d. Attach the power adapter cable into the power connector on the access

point.

e. Attach the power supply line cord to a power supply.

CAUTION

Do not actually connect to the power source until the cabling portion of

the installation is complete.

15. Verify the behavior of the access point LED light pipe. For more information, see

“LED indicators” on page 18.

16. Place the ceiling tile back in its frame and verify it is secure.

17. The access point is ready to configure. For information on basic access point

device configuration, see “Configuring basic device settings” on page 27.

LED indicators

A Brocade Mobility 7131N-FGR Access Point access point has six LEDs on the top of

the access point housing, and one optional LED light pipe at the bottom of the unit.

However, a Brocade Mobility 7131N-FGR Access Point model access point does not

use LED 6, as no third radio is available. Five LEDs illuminate (on top of the

housing) for dual radio Brocade Mobility 7131N-FGR Access Point models.

AP7131N_InstallationGuide.book Page 18 Tuesday, August 24, 2010 5:09 AM

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 64 65

No comments

Brocade Communications Systems Mobility 7131 Series Installation Guide Page 26