Brocade Communications Systems Mobility 7131 Series Installation Guide download pdf (Page 57)

Health and safety recommendations

Brocade Mobility 7131N-FGR Access Point Installation Guide 49

53-1001948-01

Power supply

Use only a Brocade approved power supply output rated at 48Vdc and minimum

0.75A. The power supply shall be Listed to UL/CSA 60950-1; and certified to

IEC60950-1 and EN60950-1 with SELV outputs.

Use only a Brocade approved power supply. Use of alternative power supply will

invalidate any approval given to this device and may be dangerous.

Wireless devices - countries

Country Selection

Select only the country in which you are using the device. Any other selection will

make the operation of this device illegal.

Operation in the US

The use on UNII (Unlicensed National Information Infrastructure) Band 1

5150-5250 MHz is restricted to indoor use only, any other use will make the

operation of this device illegal.

The available channels for 802.11 b/g operation in the US are Channels 1 to 11.

The range of channels is limited by firmware.

Radio frequency interference requirements—FCC

This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the FCC

rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However there is no

guarantee that interference will not occur in a particular installation.

AP7131N_InstallationGuide.book Page 49 Tuesday, August 24, 2010 5:09 AM

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 63 64 65

No comments

Brocade Communications Systems Mobility 7131 Series Installation Guide Page 57