BCSM IN A NUTSHELL 2008
© 2008 Brocade Communications Systems, Incorporated.
Page 12 of 44
REQUIREMENTS
To view the route between two products, the following conditions must be met:
• There must be two or more switches in the fabric
• All switches or Directors in the route must be managed by the application and attached to the same
server
• All switches or Directors in the route must be manageable products and must be running firmware
version M-EOS 7.0 or higher
• All attached products in the route must be in the same zone
PROCEDURE TO SHOW ROUTES IN EFCM
To show the route for two specific ports on the end nodes, perform the following steps:
1. In the Product List, click the + next to a switch product icon to see the nodes
2. Right-click a node and select Show Route
3. The Show Route dialog box displays
4. Select a destination node from the Destination Port table
5. Click OK. The route between the nodes displays on topology
Comments to this Manuals