ServerIron Switching and Routing Guide
2 - 36 © 2012 Brocade Communications Systems, Inc. May 2012
NOTE: An IP Protocol and IP sub-net VLAN cannot operate simultaneously on a Brocade switch or router. This
restriction is also true for IPX and IPX network VLANs. If you have previously defined an IP protocol VLAN on the
system, you need to delete it before an IP sub-net VLAN can be created.
To create an IP sub-net of IP address 192.75.3.0 with permanent port membership of 1 and 2, enter the following
commands:
BigIron(config)#ip-subnet 192.75.3.0 255.255.255.0
BigIron(config-ip-subnet)#static e1 to 2
BigIron(config-ip-subnet)#exit
Syntax: [no] ip-subnet <ip-addr> <ip-mask>
RIP
The ServerIron supports the following RIP versions:
• Version 1
• V1 compatible with V2
• Version 2 (the default)
You can configure the following parameters:
• Global parameters:
• Administrative distance
• Redistribution
• Update interval
• Learning of default route
• Advertising and learning with specific neighbors
• Interface parameters:
•RIP version
•Metric
• Learning of default route
• Split horizon
• Poison reverse
• Advertising and learning of specific routes
For comprehensive information about the RIP features and how to configure them, see the "Configuring RIP"
chapter in the Foundry Enterprise Configuration and Management Guide.
Enabling RIP
RIP is disabled by default. If you want the ServerIron to use RIP you must enable the protocol globally, then
enable RIP on the virtual routing interface and specify the version (version 1 only, version 2 only, or version 1
compatible with version 2).
To globally start the RIP process, enter the following command:
ServerIron(config)#router rip
Syntax: [no] router rip
To enable RIP on the virtual routing interface and specify the RIP version, enter the following commands:
Comments to this Manuals