Brocade Communications Systems FCX Series User Manual download pdf (Page 42)

Version 1.1, 05/19/2014

GSS CCT Evaluation Technical Report Page 42 of 53

Document: AAR-BrocadeFastIron8010

The Brocade products do not have an update available for testing. Brocade typically does not release small

updates or patches. Instead, new firmware versions are released. In order to perform this test, evaluator had to

roll back to an engineering version and then roll forward to the released product. The version did update properly.

For the improper update, the evaluator attempted to load an image that did not match the signature. The

signature verification failed.

2.7 TOE ACCESS (FTA)

2.7.1 TSF-INITIATED TERMINATION (FTA_SSL.3)

2.7.1.1 FTA_SSL.3.1

TSS Assurance Activities: None Defined

Guidance Assurance Activities: None Defined

Testing Assurance Activities: The evaluator shall perform the following test:

Test 1: The evaluator follows the operational guidance to configure several different values for the inactivity time

period referenced in the component. For each period configured, the evaluator establishes a remote interactive

session with the TOE. The evaluator then observes that the session is terminated after the configured time period.

The evaluator set the SSH time period to 2 minutes and observed a SSH timeout. The evaluator then set the SSH

timeout to 3 minutes and observed a SSH timeout. Note that when the session terminated, the screen was left as-

is and a new login prompt was presented.

2.7.2 USER-INITIATED TERMINATION (FTA_SSL.4)

2.7.2.1 FTA_SSL.4.1

TSS Assurance Activities: None Defined

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 52 53

No comments

Brocade Communications Systems FCX Series User Manual Page 42