Brocade Communications Systems StorageWorks 4400 Enterprise V User's Guide download pdf (Page 65)

6. SAN switch 22. Single HBA server (Host 1)

7. Controller A3. Dual HBA server (Host 2)

8. Controller B4. Management server

OpenVMS configuration

Requirements

• Switch zoning or controller level SSP must be used to ensure each single path HBA has an exclusive

path to its LUNs.

• All nodes with direct connection to a disk must have the same access paths available to them.

• Single path HBA server can be in the same fabric as servers with multiple HBAs.

• In the use of snapshots and snapclones, the source virtual disk and all associated snapshots and

snapclones must be presented to the single path hosts that are zoned with the same controller. In

the case of snapclones, after the cloning process has completed and the clone becomes an ordinary

virtual disk, you may present that virtual disk as you would any other ordinary virtual disk.

HBA configuration

• Host 1 is a single path HBA host.

• Host 2 is a dual HBA host.

See Figure 32.

Risks

• For nonclustered nodes with a single path HBA, a path failure from the HBA to the SAN switch

will result in a loss of connection with storage devices.

NOTE:

For additional risks, see “OpenVMS” on page 75.

Limitations

• HP Continuous Access EVA is not supported with single path configurations.

HP StorageWorks 4400 Enterprise Virtual Array user guide 65

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 127 128

No comments

Brocade Communications Systems StorageWorks 4400 Enterprise V User's Guide Page 65