Brocade Communications Systems NetIron CER Series Manual download pdf (Page 41)

Version 1.1, 03/31/2015

The evaluator set the local clock from the console and observed the time change. The evaluator then configured a

NTP server and had the appliance connect to the NTP server and update the time. The evaluator observed the time

update from the NTP server.

2.6.4 TSF TESTING (FPT_TST_EXT.1)

2.6.4.1 FPT_TST_EXT.1.1

TSS Assurance Activities: The evaluator shall examine the TSS to ensure that it details the self tests that are run by

the TSF on start-up; this description should include an outline of what the tests are actually doing (e.g., rather than

saying 'memory is tested', a description similar to 'memory is tested by writing a value to each memory location

and reading it back to ensure it is identical to what was written' shall be used). The evaluator shall ensure that the

TSS makes an argument that the tests are sufficient to demonstrate that the TSF is operating correctly.

Section 6.6 provides a discussion of the self-tests. The self-tests include basic read-write memory, flash read,

software checksum tests, and device detection tests. Additionally, the TOE is designed to query each pluggable

module which in turn includes its own diagnostics that will serve to help identify any failing modules.

Guidance Assurance Activities: The evaluator shall also ensure that the operational guidance describes the

possible errors that may result from such tests, and actions the administrator should take in response; these

possible errors shall correspond to those described in the TSS.

In the Reloading the device section of the FIPS Guide, there is a discussion of the FIPS self-tests. This discussion

also the possible errors that may arise such as:

 Crypto module initialization and KNown Answer Test (KAT) failed with reason:(Error

Code 0x80000000)’CKR_VENDOR_DEFINED’

 FIPS: MP Primary image verification failed

 FIPS: MP Secondary image verification failed

 FIPS: MP Monitor image verification failed

The Hardware Installation Guides for each model provides a Table 4 which contains all of the LEDs on the appliance

and explains what each indicator means depending on its color. For example, if the PS1 LED is yellow, the power

supply is not functioning properly.

The TSS description about the self-tests focuses on the FIPS self-tests. As such, the discussion in the FIPS Guide

discusses the possible errors that may arise and how to possibly address some of the errors

Testing Assurance Activities: None Defined

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 55 56

No comments

Brocade Communications Systems NetIron CER Series Manual Page 41