Brocade Communications Systems 8/80 Service Manual download pdf (Page 34)

ServerIron Switching and Routing Guide

Displaying the IP Host Table

To display the IP host table showing indexes to MAC addresses and the IP address of the next hop for ServerIrons

configured to operate in a multinetted environment, enter the following command:

Syntax: show ip cache [<ip-addr> [<ip-addr>]]

Displaying the ARP Cache or the Static ARP Table

You can display the ARP cache or the static ARP table. The ARP table contains the static ARP entries, if any, you

configured on the device. The ARP cache contains all the ARP entries, including static entries.

To display the ARP cache, enter the following command at any level of the CLI:

Switch IP address The management IP address you configured on the ServerIron.

Specify this address for Telnet or Web management access.

Subnet mask The sub-net mask for the management IP address.

Default router address The address of the default gateway, if you specified one.

Note: When IP forwarding is enabled, the address is listed only if the

corresponding virtual interface is up. When IP forwarding is disabled,

the configured default gateway address is always displayed.

Most recent TFTP access

TFTP server address The IP address of the most-recently contacted TFTP server, if the

ServerIron has contacted a TFTP server since the last time the

software was reloaded or the ServerIron was rebooted.

Configuration filename The name under which the ServerIron’s startup-config file was

uploaded or downloaded during the most recent TFTP access.

Image filename The name of the ServerIron flash image (system software file) that

was uploaded or downloaded during the most recent TFTP access.

Table 2.1: CLI Display of Global IP Configuration Information (Continued)

This Field... Displays...

ServerIron#[ 1] sh ip cache

IP Mac Port Age VlanId Cam CamF Hw FCnt

209.157.20.1 0000.0000.0000 6 0 3144 0 0 0 0

ServerIron(config)# show arp

IP Mac Type Port Age VlanId

10.10.10.10 00d0.0958.9b07 Static 9 0 1

192.168.2.14 0050.04bb.81fa Static 15 0 1

192.168.2.1 00e0.5205.9056 Static 15 0 1

192.168.2.157 00e0.2972.2ab5 Dynamic 15 0 1

192.168.2.15 0010.5ad1.3701 Dynamic 15 0 1

192.168.2.77 00e0.5202.de72 Dynamic 15 0 1

Total Arp Entries : 6

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 61 62

No comments

Brocade Communications Systems 8/80 Service Manual Page 34