Brocade Communications Systems Encryption Switch Service Manual download pdf (Page 73)

Fabric OS Encryption Administrator’s Guide (DPM) 55

53-1002720-02

Configuring encryption storage targets

Adding an encryption target maps storage devices and hosts to virtual targets and virtual initiators

within the encryption switch. The storage encryption wizard enables you to configure encryption for

a storage device (target).

NOTE

It is recommended that you configure the host and target in the same zone before configuring them

for encryption. If the host and target are not already in the same zone, you can still configure them

for encryption, but you will need to configure them in the same zone before you can commit the

changes. If you attempt to close the Encryption Targets dialog box without committing the changes,

you are reminded of uncommitted changes in BNA.

The wizard steps are as follows:

1. Select Encryption Engine

2. Select Target

3. Select Hosts

4. Name Container

5. Confirmation

6. Configuration Status

7. Important Instructions

Adding an encryption target

1. Select Configure > Encryption from the menu task bar to display the Encryption Center

dialog box (Refer to Figure 6 on page 14).

2. Select a group, switch, or engine from the Encryption Center Devices table to which to add the

target, then select Group/Switch/Engine > Targets from the menu task bar.

NOTE

You can also select a group, switch, or engine from the Encryption Center Devices table, then

click the Targets icon.

The Encryption Targets dialog box displays (Figure 38).

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 325 326

No comments

Brocade Communications Systems Encryption Switch Service Manual Page 73