Brocade Communications Systems Mobility 7131 Series Installation Guide download pdf (Page 56)

Wireless devices - countries

Brocade Mobility 7131 Series Access Point Installation Guide 49

53-1001935-02

Remote and standalone antenna configurations

To comply with FCC RF exposure requirements, antennas that are mounted

externally at remote locations or operating near users at stand-alone desktop of

similar configurations must operate with a minimum separation distance of 20 cm

from all persons.

Power supply

Use only a Brocade approved power supply output rated at 48Vdc and minimum

0.75A. The power supply shall be Listed to UL/CSA 60950-1; and certified to

IEC60950-1 and EN60950-1 with SELV outputs.

Use only a Brocade approved power supply. Use of alternative power supply will

invalidate any approval given to this device and may be dangerous.

Wireless devices - countries

Country selection

Select only the country in which you are using the device. Any other selection will

make the operation of this device illegal.

Operation in the US

The use on UNII (Unlicensed National Information Infrastructure) Band 1

5150-5250 MHz is restricted to indoor use only, any other use will make the

operation of this device illegal.

The available channels for 802.11 b/g operation in the US are Channels 1 to 11.

The range of channels is limited by firmware.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 62 63 64

No comments

Brocade Communications Systems Mobility 7131 Series Installation Guide Page 56