Brocade Communications Systems Mobility 7131 Series Installation Guide download pdf (Page 9)

Warnings

2 Brocade Mobility 7131 Series Access Point Installation Guide

53-1001935-02

Warnings

• Read all installation instructions and site survey reports, and verify correct

equipment installation before connecting the access point to its power source.

• Remove jewelry and watches before installing this equipment.

• Verify that the unit is grounded before connecting it to the power source.

• Verify that any device connected to this unit is properly wired and grounded.

• Connect all power cords to a properly wired and grounded electrical circuit.

• Verify that the electrical circuits have appropriate overload protection.

• Attach only approved power cords to the device.

• Verify that the power connector and socket are accessible at all times during

the operation of the equipment.

• Do not work with power circuits in dimly lit spaces.

• Do not install this equipment or work with its power circuits during

thunderstorms or other weather conditions that could cause a power surge.

• Verify there is adequate ventilation around the device, and that ambient

temperatures meet equipment operation specifications.

• Before installing or handling the Mobility 7131 Series Access Points, have on hand

an ESD wrist strap or other ESD voltage limiting device.

CAUTION

For safety reasons, the ESD wrist strap should contain a 1 meg ohm series

resistor.

Site preparation

• Consult your site survey and network analysis reports to determine specific

equipment placement, power drops, and so on.

• Assign installation responsibility to the appropriate personnel.

• Identify and document where all installed components are located.

• Provide a sufficient number of power drops for your equipment.

• Ensure adequate, dust-free ventilation to all installed equipment.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 63 64

No comments

Brocade Communications Systems Mobility 7131 Series Installation Guide Page 9