Brocade Communications Systems ADX 10000 Installation Guide download pdf (Page 45)

Brocade ServerIron ADX Installation Guide 35

53-1003445-01

Installing ServerIron ADX

FIGURE 26 Installing a Power Supply in a ServerIron ADX 4000, ServerIron ADX 8000 or ServerIron ADX 10000

Chassis (ServerIron ADX 8000 Shown)

4. Install a blank power supply faceplate into each slot that is empty after all of the power

supplies have been installed.

5. After the power supply is fully inserted, push the power supply front panel toward the back of

the chassis. This action causes the power supply connector to latch into the backplane

connector.

6. Gently pull the handle on the power supply front panel upward and toward the top of the power

supply front panel. This action locks the power supply in place.

7. For information about connecting power to the chassis, refer to “Connecting AC power” on

page 35, or “Connecting DC power to a chassis” on page 38.

Connecting AC power

AC power is supplied through an AC power cord. The cord is installed at the back of the ServerIron

ADX 1000 chassis and at the front of the ServerIron ADX 4000, ServerIron ADX 8000 and

ServerIron ADX 10000 chassis.

NOTE

For the NEBS compliant installation, AC power connections shall use a SPD (surge protection device)

in order to protect the AC power supplies from damage to excessive power line surges.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 102 103

No comments

Brocade Communications Systems ADX 10000 Installation Guide Page 45