Brocade Communications Systems ADX 10000 Installation Guide download pdf (Page 80)

70 Brocade ServerIron ADX Installation Guide

53-1003445-01

Port specifications

ports as described in GR-1089-CORE, Issue 4) and require isolation from the exposed OSP

cabling. The addition of Primary Protectors is not sufficient protection in order to connect these

interfaces metallically to OSP wiring.

Console Port Pin assignments

The console port is a standard male DB-9 connector, as shown in Figure 46. For information about

how you can use this port, refer to “Attaching a PC or terminal to the Console port or Ethernet port”

on page 43.

FIGURE 46 Console Port Pin and Signalling Details

Most PC serial ports require a cable with a female DB-9 connector. However, terminal connections

will vary, requiring a cable with either a DB-9 or DB-25 connector, male or female.

Serial cable options between the ServerIron ADX chassis and a PC or terminal are shown in

Figure 47.

NOTE

As indicated in Figure 46 and Figure 47, some of the wires should not be connected. If you do

connect the wires that are labeled “Reserved”, you might get unexpected results with some

terminals.

FIGURE 47 Console Port Pin Assignments Showing Cable Connection Options to a Terminal or PC

Management Port Pin assignments

The management port is an RJ-45 UTP connector. Table 11 describes the connector pin

assignments. For information about how you can use this port, refer to “Attaching the management

module Ethernet port to a network” on page 44.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 102 103

No comments

Brocade Communications Systems ADX 10000 Installation Guide Page 80