Brocade Communications Systems 4900 Service Manual download pdf (Page 58)

36 Web Tools Administrator’s Guide

Publication Number: 53-1000435-01

Managing blades

3. Click the Set IP address button.

FIGURE 19 Set IP Address dialog box

4. Select a slot number from the drop-down list.

5. Enter the IP address, subnet mask, and Gateway IP address.

6. Select a type from the drop-down list.

7. Click Add to add the new entry to the table.

When you click the Add button, the values remain in the fields.

8. To delete a configuration, select a row in the table and click the Delete button.

NOTE

Clicking the Add or Delete buttons update the table in the Set IP Address dialog box, but does

not send values to the switch.

9. Click the Apply button to save the values currently shown in the table to the switch or click

Cancel to close the dialog box without saving any of your changes.

To update the switch with you changes, you must update the table using the Add and Delete

buttons, and then click Apply.

View IP addresses

If you want to view the IP addresses configured on the switch for the currently populated slots, use

the Show IP Address button.

To view the IP addresses

1. Open the Switch Administration window as described on page 31.

2. Click the Blade tab.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 265 266

No comments

Brocade Communications Systems 4900 Service Manual Page 58