Brocade Communications Systems ServerIron ADX 12.4.00 Service Manual Page 148

  • Download
  • Add to my manuals
  • Print
  • Page
    / 188
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 147
ServerIron ADX Firewall Load Balancing Guide 137
53-1002436-01
Configuring SLB-to-FWLB
6
DRAFT: BROCADE CONFIDENTIAL
Figure 21 shows an example of an FWLB-to-SLB configuration.
FIGURE 21 FWLB-to-SLB configuration
For FWLB-to-SLB, all the SLB configuration information is on the internal ServerIron ADX (ServerIron
ADX B).
Configuring SLB-to-FWLB
To configure SLB-to-FWLB in a basic FWLB configuration for Layer 3 firewalls, such as the one
shown in
Figure 20, perform the following tasks:
Configure SLB parameters on the Internet ServerIron:
- Configure the real servers
- Configure the virtual server
- Bind the real servers to the virtual server
- Enable the SLB-to-FWLB feature
Configure global FWLB parameters
Configure firewall parameters:
Define the firewalls and add them to the firewall group
Configure firewall group parameters:
Configure the paths and add static MAC entries for the firewall interfaces with the ServerIron
ADX
SI-A
SI-B
WAN Router
Internal Router
Internet
192.168.1.100
Port e3 Port e5
FW-1
FW-2
FW1-IPin
192.168.1.30
MAC:
abcd.4321.34e0
FW2-IPin
192.168.1.40
MAC:
abcd.4321.34e1
FW1-IPout
192.168.2.30
MAC:
abcd.4321.34e2
FW1-IPout
192.168.2.40
MAC:
abcd.4321.34e3
Port e1 Port e2
192.168.2.200
Real Server
192.168.2.50
Real Server
192.168.2.60
SLB Configuration
- Real Servers 192.168.2.50 and 192.168.2.60
- Real Servers are defined as local because
proxy ARP is enabled on the Internal Router
- Virtual Server 192.168.2.2
- Servers bound by TCP port 80
- FWLB-to-SLB is enabled
NOTE: All SLB configuration
is on the Internet ServerIron
(ServerIron A)
Page view 147
1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 187 188

Comments to this Manuals

No comments