ServerIron ADX Firewall Load Balancing Guide 45
53-1002436-01
Configuring HA active-active FWLB
3
DRAFT: BROCADE CONFIDENTIAL
The <tcp/udp-port> parameter can be a number from 1 through 65535 or one of the following
well-known port names:
• dns – port 53
• ftp – port 21 (Ports 20 and 21 are FTP ports but in the ServerIron ADX, the name “ftp”
corresponds to port 21.)
• http – port 80
• imap4 – port 143
• ldap – port 389
• nntp – port 119
• ntp – port 123
• pop2 – port 109
• pop3 – port 110
• radius – UDP port 1812
• radius-old – The ServerIron ADX name for UDP port 1645, which is used in some older RADIUS
implementations instead of port 1812
• smtp – port 25
• snmp – port 161
• ssl – port 443
• telnet – port 23
• tftp – port 69
The no-health-check parameter disables the Layer 4 path heath check for this application port.
Layer 4 health checks are enabled by default.
To configure the IPv6 firewalls on ServerIron ADX, enter the following commands.
ServerIronADX(config)# server fw-name ip6fw1 1112::2
ServerIronADX(config-rs-ip6fw1)# end
ServerIronADX(config)# server fw-name ip6fw2 1112::3
ServerIronADX(config-rs-ip6fw2)# end
ServerIronADX(config)# server fw-group 4 ipv6
ServerIronADX(config-fw-4)# fw-name ip6fw1
ServerIronADX(config-fw-4)# fw-name ip6fw2
Syntax: [no] server fw-name <string> <ipv6-addr>
Comments to this Manuals