Brocade Communications Systems Mobility 7131 Series Service Manual Page 65

  • Download
  • Add to my manuals
  • Print
  • Page
    / 520
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 64
Brocade Mobility 7131 Access Point Product Reference Guide 53
53-1002517-01
3
2. To view the IP address, connect one end of a null modem serial cable to the access point and
the other end to the serial port of a computer running HyperTerminal or similar emulation
program.
3. Configure the following settings:
Baud Rate - 19200
Data Bits - 8
Stop Bits - 1
No Parity
No Flow Control
4. Press <ESC> or <Enter> to access the access point CLI.
5. Enter the default username of “admin” and the default password of “admin123.
As this is the first time you are logging into the access point, you are prompted to enter a
new password and set the county code. Refer to Country Codes on page A-491 for a list of
each available countries two digit country code.
6. At the CLI prompt (admin>), type “summary.”
The access point’s LAN IP address will display.
7. Using a Web browser, use the access point’s IP address to access the access point.
8. Refer to Basic Device Configuration on page 3-53 for instructions on the initial (basic)
configuration of the access point.
Basic Device Configuration
For the basic setup described in this section, the Java-based Web UI will be used to configure the
access point. Use the access point’s LAN interface for establishing a link with the access point.
Configure the access point as a DHCP client. For optimal screen resolution, set your screen
resolution to 1024 x 768 pixels or greater.
1. Log in using admin as the default Username and admin123 as the default Password. Use your
new password if it has been updated from default.
NOTE
For optimum compatibility, use Sun Microsystems’ JRE 1.5 or higher (available from Suns Website),
and be sure to disable Microsoft’s Java Virtual Machine if installed.
Page view 64
1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 519 520

Comments to this Manuals

No comments