Brocade Communications Systems Mobility 7131 Series Service Manual download pdf (Page 81)

Brocade Mobility 7131 Access Point Product Reference Guide 69

53-1002517-01

3. Refer to the Factory Defaults field to restore either a full or partial default configuration.

CAUTION

Restoring the access point’s configuration back to default settings changes the administrative

password back to “admin123.” If restoring the configuration back to default settings, be sure you

change the administrative password accordingly.

Country The Mobility 7131 Access Point prompts the user for the correct country code after the first

an illegal use of the access point. Use the pull-down menu to select the country of

operation. Selecting the correct country is extremely important. Each country has its own

regulatory restrictions concerning electromagnetic emissions (channel range) and the

maximum RF signal strength transmitted. To ensure compliance with national and local

laws, be sure to set the

Country field correctly.

If using the Mobility 7131 Access Point configuration file, CLI or MIB to configure the

Mobility 7131 Access Point’s country code, see Country Codes on page A-491.

Disable LEDs Select the

Disable LEDs radio button to stop the access points LEDs from blinking during

startup and normal operation. Selecting this option turns off all of the access point’s light

pipes and none of the access point’s states are displayed by the LEDs. This option is

disabled by default.

AP-71XX Version The dIsplayed number is the current version of the device firmware. Use this information to

determine if the access point is running the most recent firmware available from Brocade

Mobility. Use the

Firmware Update screen to keep the AP’s firmware up to date. For more

information, see Updating Device Firmware on page 4-109.

System Uptime Displays the current uptime of the Mobility 7131 Access Point defined in the System Name

field. System Uptime is the cumulative time since the Mobility 7131 Access Point was last

rebooted or lost power.

Serial Number Displays the Mobility 7131 Access Point Media Access Control (MAC) address. The Mobility

7131 Access Point MAC address is hard coded at the factory and cannot be modified. The

LAN and WAN port MAC addresses can be located within the LAN and WAN Stats screens.

For information on locating the access point MAC addresses, see Viewing WAN Statistics on

page 7-253 and Viewing LAN Statistics on page 7-256.

AP Mode Displays the access point’s mode of operation to convey whether the access point is

functioning as a standalone access point (Independent mode) or in Adaptive (thin AP)

mode. If in Adaptive mode, the access point attempts to discover a switch through one or

more of several mechanisms: DNS, DHCP, ICMP, CAPWAP or a statically programmed IP

address. For information on adaptive AP, see, Adaptive AP on page 10-471.

Enable DNS Relay Select the radio button to enable DNS relay. DNS relay is used to prevent access to the port

used by DNS. If disabled, clients connected to the access point are not able to browse sites

since DNS is disabled. This feature is enabled by default.

Enable SSLv2 Mode Select the radio button to enable SSL (Secure Socket Layer) version 2 support. SSL

provides session encryption and message authentication. This feature is enabled by

default.

Enable SSHv1 Mode Select the radio button to enable SSH version 1 support. Secure Shell (SSH) is a protocol

that provides a secure, remote connection to an access point. This feature is enabled by

default.

Enable Weak Cipher

Support

Select the radio button to enable the access point to support SSL ciphers less than 128 bits

in length. This feature is enabled by default.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 519 520

Comments to this Manuals

No comments

Brocade Communications Systems Mobility 7131 Series Service Manual Page 81

Comments to this Manuals

Related products and manuals for WLAN access points Brocade Communications Systems Mobility 7131 Series