Brocade Communications Systems Mobility 7131 Series Service Manual download pdf (Page 64)

52 Brocade Mobility 7131 Access Point Product Reference Guide

53-1002517-01

• Secure Java-Based WEB UI - (use Sun Microsystems’ JRE 1.5 or higher available from Sun’s

Web site. Disable Microsoft’s Java Virtual Machine if installed). For information on using the

Web UI to set Mobility 7131 Access Point default configuration, see Basic Device Configuration

on page 3-53 or chapters 4 through 7 of this guide.

• Command Line Interface (CLI) via Serial, Telnet and SSH. The access point CLI is accessed

through the RS232 port, via Telnet or SSH. The CLI follows the same configuration conventions

as the device user interface with a few documented exceptions. For details on using the CLI to

manage the access point, see CLI Reference on page 8-281.

• Config file - Readable text file; Importable/Exportable via FTP, TFTP and HTTP. Configuration

settings for an access point can be downloaded from the current configuration of another

access point meeting the import/export requirements. For information on importing or

exporting configuration files, see Importing/Exporting Configurations on page 4-104.

• MIB (Management Information Base) accessing the Mobility 7131 Access Point SNMP

functions using a MIB Browser. The access point download package contains the following 2

MIB files:

• Symbol-CC-WS2000-MIB-2.0

• Symbol-AP_MIB

Initially Connecting to the Access Point

NOTE

The procedures described below assume this is the first time you are connecting to a Mobility 7131

or Mobility 7131N model access points.

NOTE

The computer being used should be configured to use the same IP address and subnet mask as the

access point.

Connecting to the Access Point using the WAN Port

To initially connect to the access point using the access point’s WAN port:

8. Connect AC power to the access point, as Power-Over-Ether support is not available on the

access point’s WAN (or GE2) port.

9. Start a browser and enter the access point’s static IP address (10.1.1.1). The default password

is “admin123.”

10. Refer to Basic Device Configuration on page 3-53 for instructions on the initial (basic)

configuration of the access point.

Connecting to the Access Point using the LAN Port

To initially connect to the access point using the access point’s LAN port:

1. The LAN (or GE1/POE) port default is set to DHCP. Connect the access point’s GE1/POE port to

a DHCP server.

The access point will receive its IP address automatically.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 519 520

No comments

Brocade Communications Systems Mobility 7131 Series Service Manual Page 64