Brocade Communications Systems NetIron CER Series Installation Guide download pdf (Page 95)

4. Slide the new fan tray in and tighten the screws to secure it to the chassis.

5. Plug the chassis back in and power up.

Copper or Fiber optic module replacement

You can remove an SFP, SFP+, or XFP from a port and replace it with a new one while the Brocade

device is powered on and running.

This section provides information about the following tasks:

• Removing a copper or fiber optic module

• Installing a new copper or fiber optic module

• Cabling a fiber optic module

Removing a Copper or fiber optic module

You can remove a copper or fiber SFP (also called a mini-GBIC), SFP+, or an XFP from a port while the

Brocade device is powered on and running.

Before removing a copper or fiber optic module, have the following on hand:

• An ESD wrist strap with a plug for connection to the ESD connector on the Stackable device.

DANGER

For safety reasons, the ESD wrist strap should contain a series 1 megaohm resistor.

• The protective covering that you removed from the copper or fiber optic module when you initially

installed the module.

Follow the steps given below to remove a copper or fiber optic module from a Gigabit Ethernet or 10-

Gigabit Ethernet port.

1. Put on the ESD wrist strap and ground yourself by attaching the clip end to a metal surface (such as

an equipment rack).

2. Disconnect the copper or fiber cable connector from the port connector.

3. Insert the protective covering into the port connectors.

FIGURE 58 Pull the copper or fiber optic module out of the port by pulling the bail latch forward,

away from the front panel of the module. This unlocks the module from the front panel. On

1000BaseSX ports, the bail latch is enclosed in a black sleeve, and on 1000BaseLX ports, the bail

latch is enclosed in a blue sleeve.

Copper or Fiber optic module replacement

Brocade NetIron CES 2000 Series and NetIron CER 2000 Series Hardware Installation Guide 95

53-1003263-02

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 119 120

No comments

Brocade Communications Systems NetIron CER Series Installation Guide Page 95