Brocade Communications Systems ServerIron ADX 12.4.00 Service Manual download pdf (Page 12)

ServerIron ADX Firewall Load Balancing Guide 1

53-1002436-01

DRAFT: BROCADE CONFIDENTIAL

Chapter

ServerIron FWLB Overview

In this chapter

•Understanding ServerIron FWLB . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1

•Basic FWLB topology . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11

•HA FWLB topology . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12

•Multizone FWLB topology . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14

Understanding ServerIron FWLB

Firewall Load Balancing (FWLB) allows the ServerIron ADX to balance traffic on multiple firewalls.

The ServerIron ADX supports the following IPv4 FWLB topologies: Basic FWLB, High Availability (HA)

FWLB, and Multizone FWLB.

NOTE

The ServerIron ADX supports the following IPv4 topologies: FWLB + NAT, FWLB + SYN Proxy, FWLB +

L4 SLB.

NOTE

The ServerIron ADX supports the following IPv6 FWLB topologies: Basic FWLB and High Availability

(HA) FWLB.

NOTE

IPv6 FWLB is only available on the Router Image.

You can configure FWLB for IPv6 topologies; however, the command line interface (CLI) does not

accept IPv6 addresses for all commands.

Table 1 provides a list of affected commands that enable

you to configure IPv6 FWLB as well as the show commands.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 187 188

No comments

Brocade Communications Systems ServerIron ADX 12.4.00 Service Manual Page 12