ServerIron ADX Firewall Load Balancing Guide 163
53-1002436-01
Displaying the firewall selected by the hashing process for load balancing
7
DRAFT: BROCADE CONFIDENTIAL
The <src-ipv6-addr> parameter specifies the source IPv6 address.
The <fwall-group-id> parameter specifies the FWLB group ID. For IPv4, the FWLB group ID is 2. For
IPv6, the FWLB group ID is 4.
The <protocol> parameter specifies the protocol number for TCP or UDP. You can specify one of the
following:
• 6 – TCP
• 17 – UDP
The <dst-tcp/udp-port> specifies the destination TCP or UDP application port number.
The <src-tcp/udp-port> specifies the source TCP or UDP application port number.
If you configured the ServerIron ADX to hash based on source and destination TCP or UDP
application ports as well as IP addresses, the ServerIron ADX might select more than one firewall
for the same pair of source and destination IP addresses, when the traffic uses different pairs of
source and destination application ports. Use the optional parameters to ensure that the
command’s output distinguishes among the selected firewalls based on the application ports.
Here is an IPv4 example:
ServerIronADX# show fw-hash 1.1.1.1 2.2.2.2 2 6 80 8080
ServerIronADX# show fw-hash 1.1.1.1 2.2.2.2 2 6 80 9000
Here is an IPv6 example:
ServerIronADX# show fw-hash 33::1 33::2 4 6 80 8080
Comments to this Manuals