Brocade Communications Systems VDX 8770-8 Installation Guide download pdf (Page 73)

a) Enter the configure terminal command to enter global configuration mode

b) Enter the rbridge-id rbridge-idcommand to enter RBridge ID configuration mode.

c) Enter the no linecard slot_numbercommand. This command removes the line card

configuration and its associated interface configuration from the chassis database so a

different type of line card can be used in the slot.

5. Disconnect all cables and transceivers from the line card.

6. Unscrew the two captive screws at the ends of the line card using the Phillips screwdriver.

7. Open the ejectors by rotating them toward the center of the line card face. Pull the line card out of the

chassis using the ejectors.

FIGURE 21 Removal and replacement of the line card

8. If you are replacing the line card with a line card of a different type, follow these steps before

replacing the line card.

a) Enter the linecard slot_number command followed by a question mark (?) to display the line

card types.

b) Enter the linecard slot_number linecard_type command using the proper line card type.

c) Enter the exit command twice to return to privileged EXEC mode.

Replacing a line card

Review the ESD precautions on page 69 before replacing a line card.

Complete this procedure to insert a new line card. Refer to the illustration provided with the procedure.

1. If you are replacing the line card with a line card of a different type, follow these steps:

Replacing a line card

Brocade VDX 8770-8 Hardware Installation Guide 73

53-1002564-07

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 115 116

No comments

Brocade Communications Systems VDX 8770-8 Installation Guide Page 73