124 ServerIron ADX Firewall Load Balancing Guide
53-1002436-01
Configuring IronClad Layer 3 FWLB for NAT
5
DRAFT: BROCADE CONFIDENTIAL
Commands for standby ServerIron ADX A (external standby)
SI-StandbyA(config)# server fw-name fw1 192.168.2.2
SI-StandbyA(config-rs-fw1)# exit
SI-StandbyA(config)# server fw-name fw2 192.168.2.3
SI-StandbyA(config-rs-fw2)# exit
SI-StandbyA(config)# fw-group 2
SI-StandbyA(config-fw-2)# fw-name fw1
SI-StandbyA(config-fw-2)# fw-name fw2
Commands for active ServerIron ADX B (internal active)
SI-ActiveB(config)# server fw-name fw1 4.4.4.10
SI-ActiveB(config-rs-fw1)# exit
SI-ActiveB(config)# server fw-name fw2 4.4.4.11
SI-ActiveB(config-rs-fw2)# exit
SI-ActiveB(config)# server fw-group 2
SI-ActiveB(config-fw-2)# fw-name fw1
SI-ActiveB(config-fw-2)# fw-name fw2
Commands for standby ServerIron ADX B (internal standby)
SI-StandbyB(config)# server fw-name fw1 3.3.3.10
SI-StandbyB(config-rs-fw1)# exit
SI-StandbyB(config)# server fw-name fw2 3.3.3.11
SI-StandbyB(config-rs-fw2)# exit
SI-StandbyB(config)# server fw-group 2
SI-StandbyB(config-fw-2)# fw-name fw1
SI-StandbyB(config-fw-2)# fw-name fw2
Syntax: [no] server fw-name <string> <ip-addr>|<ipv6-addr>
When you add a firewall name, the CLI level changes to the firewall level. This level is used when
you configure stateful FWLB.
Syntax: server fw-group 2 | 4
This command changes the CLI to the firewall group configuration level. The IPv4 address format
firewall group number is 2. The IPv6 address format firewall group number is 4. These are the only
supported firewall groups.
Syntax: [no] fw-name <string>
This command adds a configured firewall to the firewall group.
Comments to this Manuals