Brocade Communications Systems Brocade Superx Series Installation Guide download pdf (Page 119)

Brocade FastIron SX Series Chassis Hardware Installation Guide 107

53-1002500-01

Replacing a management module

• A #2 Phillips-head or flathead screwdriver.

To remove a management module from the chassis, perform the following tasks.

1. Refer to “Installation precautions” on page 106.

2. If your Brocade chassis does not have redundant management modules, power down the

chassis and remove the power cables from the chassis power supplies.

3. Put on the ESD wrist strap and ground yourself by inserting the plug into the ESD connector

located on the chassis front.

4. Use a #2 Phillips-head or flathead screwdriver to loosen and remove the two screws on the

ends of the module.

5. Pull the card ejectors towards you, and away from the module front panel. This action unseats

the module from the backplane.

6. Pull the module out of the chassis, and place in an anti-static bag for storage if desired.

7. Install a new module in the slot. For information about performing this task, refer to “Installing

a new management module”.

Installing a new management module

Before installing a module into the chassis, have the following on hand:

• A new management module, which you can order from Brocade.

• An ESD wrist strap with a plug for connection to the ESD connector on the chassis.

DANGER

For safety reasons, the ESD wrist strap should contain a series 1 megohm resistor.

• A #2 Phillips-head or flathead screwdriver.

To install a new management module in the chassis, perform the following tasks.

1. Refer to “Installation precautions” on page 106.

2. If your Brocade chassis does not have redundant management modules, power down the

chassis and remove the power cables from the chassis power supplies.

3. Put on the ESD wrist strap and ground yourself by inserting the plug into the ESD connector

located on the chassis front.

4. Remove the new management module from its packaging.

5. Insert the module into the chassis slot as shown in Figure 7 and Figure 47, and slide the card

along the card guide until the ejectors on either side of the module move close to the module

front panel.

6. Push the ejectors toward the center of the module. This action will fully seat the module in the

backplane.

7. Use a #2 Phillips-head or flathead screwdriver to tighten the two screws at either end of the

management module’s front panel.

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 187 188

No comments

Brocade Communications Systems Brocade Superx Series Installation Guide Page 119