Brocade Communications Systems VDX 8770-8 Installation Guide download pdf (Page 71)

FIGURE 20 Removal and replacement of the cable management comb

Replacing a cable management comb

Complete the following steps to replace the cable management comb.

1. Position and tighten the four (4) screws to secure the new cable management comb to the chassis.

2. Arrange the cables in the cable management comb.

Line card removal and replacement

This section describes the physical procedure for removing and replacing line cards in chassis slots. It

does not cover the management modules or the switch fabric modules.

If are replacing a line card with a different type of line card, after removing the original line card, you

must enter the Network OS no linecard slot_number command while in RBridge ID configuration

mode to clear the current slot configuration. You must also select the new line card type using the

linecard slot_number linecard_type command before installing the new line card. For more detailed

command steps, consult procedures in this section for removing and replacing a line card and in the

Network OS Administration Guide.

Install a new line card only if it is supported by the firmware running in the chassis. Inserting a line card

into a chassis running firmware that does not support the line card may result in unexpected behavior.

Replacing a cable management comb

Brocade VDX 8770-8 Hardware Installation Guide 71

53-1002564-07

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 115 116

No comments

Brocade Communications Systems VDX 8770-8 Installation Guide Page 71