Brocade Communications Systems NetIron CER Series Installation Guide download pdf (Page 50)

Redundant power supply installation

The Brocade device ships with one alternating-current (AC) power supply or direct-current (DC) power

supply. All models have two power supply slots, enabling you to install a second power supply for

redundancy. If desired, you can install a second supply for redundancy.

CAUTION

Changes or modifications made to this device that are not expressly approved by the party

responsible for compliance could void the user's authority to operate the equipment.

If you need to install a redundant power supply, it may be easier to install it before mounting the

device, although the power supplies are "hot swappable" and can be installed or removed after the

device is mounted and powered on.

This section provides the following procedures:

• Installing a redundant AC power supply - Installing an AC power supply on page 50

• Installing a redundant DC power supply - Installing a DC power supply on page 52

Installing an AC power supply

DANGER

Before beginning the installation, see the precautions in “Power precautions.”

FIGURE 36 Use the following procedures for AC power supplies in Brocade NetIron CES Series,

Brocade NetIron CER Series 2000 series devices.

Redundant power supply installation

50 Brocade NetIron CES 2000 Series and NetIron CER 2000 Series Hardware Installation Guide

53-1003263-02

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 119 120

No comments

Brocade Communications Systems NetIron CER Series Installation Guide Page 50