Brocade Communications Systems NetIron CER Series Installation Guide download pdf (Page 86)

FIGURE 51 Power supply installation

CAUTION

Carefully follow the mechanical guides on each side of the power supply slot and make sure

the power supply is properly inserted in the guides. Never insert the power supply upside

down.

4. Tighten the two power supply locking screws located at the top left and bottom right hand corner of

the power supply.

5. Connect the power cord to the power supply.

Removing the DC power supply

Required tools

You will need the following tool to perform this procedure:

• #2 Phillips-head screwdriver

The following procedures are required when removing an DC power supplies from devices.

1. Remove the wires from your DC power source.

2. Unscrew the two assembly screws to unlock the DC wiring assembly (Required tools) and remove

the adapter.

3. Loosen the wire tightening screws to remove the wires (Required tools) from the DC wiring

assembly.

Removing the DC power supply

86 Brocade NetIron CES 2000 Series and NetIron CER 2000 Series Hardware Installation Guide

53-1003263-02

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 119 120

No comments

Brocade Communications Systems NetIron CER Series Installation Guide Page 86