Brocade Communications Systems NetIron CER Series Installation Guide download pdf (Page 88)

FIGURE 53 The DC wiring assembly

1 Wire tightening screws 2 Assembly screws

5. Pull the power supply outward once the screws have been unscrewed. This will disconnect the

power supply from the backplane. Pull it completely free of the chassis.

6. Place the power supply in an anti-static bag for storage.

7. Insert a new supply, or place and screw in a cover plate over the empty power supply. Refer to

Installing a DC power supply on page 88 for details.

Installing a DC power supply

DANGER

Before beginning the installation, refer to the precautions in Installing a DC power supply.

Use the following procedures for DC power supplies in Brocade devices.

Follow the steps given below to install an DC power supply.

1. If necessary, remove the power supply locking screws located in the upper left and the bottom right

of the device.

2. If the empty power supply bay has a cover plate, remove the two screws near the edges of the

cover plate to unlock the plate, then remove the plate.

3. Remove the DC power supply from its packaging (Installing a DC power supply).

Installing a DC power supply

88 Brocade NetIron CES 2000 Series and NetIron CER 2000 Series Hardware Installation Guide

53-1003263-02

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 119 120

No comments

Brocade Communications Systems NetIron CER Series Installation Guide Page 88